Oliver 10040, Руководство пользователя

Страница: 22 / 38

21
.
MAINTENANCE & ADJUSTMENTS
ADJUSTING THE 45° & 90° BEVEL STOPS
1. Disconnect the machine from the power
source.
2. Raise the blade to its highest position and lift
the blade guard.
3. Loosen the bevel lock knob and turn the
blade tilting handwheel clockwise until it
stops.
4. Verify the angle of the blade with a
combination square from the left side of the
blade, keep the square flat against the table
and against the flat part of the blade. Do not
touch the teeth or the table insert.
If the blade 90° angle is incorrect, remove the
motor cover G Fig.25 by phiIlips screw driver
then loosen the Hex. Nut C, Fig.26 then turn
the 90° stop screw D, Fig. 26 under the table
by Hex. wrench. Turn the hand wheel until the
blade is at 90° to the table surface. Then
re-tighten the 90° stop screw & Hex. nut until
slight resistance is felt. Do not over tighten stop
screw.
Verify the 45° setting by tilting the blade as far
as possible to the left and using the square,
check the angle and if needed adjust as for the
90° stop, this time remove the storage box H,
Fig.27 by phiIlips screw driver then loosen the
Hex. Nut E, Fig.27 then turn the 45° stop screw
F, Fig.27 under the table by Hex. wrench. Turn
the hand wheel until the blade is at 45° to the
table surface. Then re-tighten the 45° stop
screw & Hex. nut until slight resistance is felt.
Do not over tighten stop screw.
ADJUSTING THE BEVEL ANGLE POINTER
The bevel pointer should read “0” when the
blade is at 90° to the table. If not, with the
blade set 90° vertical to the table, proceed as
follows:
1. Remove the handwheel by loosening the
handwheel lock knob I Fig. 28
2. Once the hand wheel has been removed,
loosen the cap screw on the pointer
mounting bracket with screw driver Fig. 29,
and manually align the pointer with the zero
on the bevel scale, then re-tighten the screw
and re-attach the hand wheel.
WARNING:
MAKE SURE THE SAW HAS BEEN
TURNED OFF AND UNPLUGGED FROM THE
POWER SOURCE BEFORE PERFORMING
ANY MAINTENANCE.
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Fig. 29
G
H
!
！
I
A
C
D
C
A
F
E