16
SAW BLADE
In Fig. 9
This saw with 10" (250mm) diameter
having a center hole diameter of 5/8". Be
sure disconnect table saw from power
source before operation.
Warning: Always wear gloves when
handling saw blades.
1. Set the blade to 90º and
raise it to its highest position.
2. Loosen the Lock Knob Fig.7 on the Table
Insert then remove the table insert and blade
guard/riving knife, depending on what is
installed.
3. Find a corner cut Fig. 9 on the arbor , push
the red bar Fig. 9 into the corner cut as close
to saw blade for stop the arbor and use the
arbor wrench to loosen and remove the arbor
nut, flange, and blade (Fig. 10).
Note: Loosen the arbor nut by
counterclockwise.
4. Reinstall the arbor flange and arbor nut then
tighten them against the blade. Do not over
tighten.
Slide the blade over the arbor with the teeth
facing the front of the saw Re-install the arbor
flange and arbor nut, and tighten them
against the blade.
Do not overtighten.
5. Re-install the blade guard/riving knife and
table insert.
WARNING: ALWAYS TURN OFF AND
UNPLUG THE SAW BEFORE REMOVING/
NSTALLING A RIVING KNIFE.
Fig. 9
Fig. 10
!
！
Corner Cut
Red Bar
