2
READ CAREFULLY BEFORE OPERATING THE MACHINE
WARNING – To reduce the risk of injury, user must read instruction manual
a) DANGER – Never place your hands in the vicinity or in line with the saw blade.
b) WARNING – Wear eye protection² or the sign M004 of ISO 7010.
c) WARNING – Always use a properly functioning saw-blade guard, riving knife and
anti-kickback device for every operation for which it can be used, including all through sawing.
d) WARNING – Use a push-stick or push-block when required.
e) WARNING – Do not perform any operation freehand.
f) WARNING – Pay particular attention to instructions on reducing risk of kickback. (or “Know
how to reduce risk of kickback.”)
g) WARNING – Never reach around or over saw blade. (or “Never reach in back of or over saw
blade.”)
h) WARNING – Turn off tool and wait for saw blade to stop before moving workpiece or changing
settings.
i) WARNING – Never stand 5428markdirectly in line with the saw blade. Always position your body
on the same side of the saw blade as the fence.
j) Keep hands out of the line of saw blade.
k) DON'T USE IN DANGEROUS ENVIRONMENT. Don't use power tools in damp or wet locations,
or expose them to rain. Keep work area well lighted.
m) MAKE WORKSHOP KID PROOF with padlocks, master switches, or by removing starter keys.
n) USE RIGHT TOOL. Don't force tool or attachment to do a job for which it was not designed.
o) WEAR PROPER APPAREL Do not wear loose clothing, gloves, neckties, rings, bracelets, or
other jewelry which may get caught in moving parts. Nonslip footwear is recommended. Wear
protective hair covering to contain long hair.
p) ALWAYS USE SAFETY GLASSES. Also use face or dust mask if cutting operation is dusty.
Everyday eyeglasses only have impact resistant lenses, they are NOT safety glasses.
q) CHECK DAMAGED PARTS. Before further use of the too., a guard or other part that is damaged
should be carefully checked to determine that it will operate properly and perform its intended
function - check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
8.8 Except for TYPE Z ATTACHMENT, terminals shall be indicated as follows:
– Terminals intended exclusively for the neutral conductor shall be indicated by the letter N.
– Earthing terminals shall be indicated by the symbol IEC 60417-5019 (2006-08).
