13
REAR RAIL INSTALLED
1. Use 3 Cap screws with lock washers and
nuts by Hex. Wrench to assemble the rear
rails to the rear of the saw as shown
Option:
RIGTH TABLE OF 52” RAIL INSTALLED
1. To place the right table assembly upright
with extension table and
align
to the front
rail mounting holes, then fasten the table to
the front rail with two M8 hex bolts, 8 mm
flat washers, and M8 hex nuts then fasten
the table to the rear rail with two CAP screw
w/ lock washers, 8 mm flat washers, and M8
hex nuts.
2. Install each foot with a M8 Hex nut A into
the bottom of a support leg.
3. Fasten support leg to the main extension
table on front rail with two M8 hex bolts, 8
mm flat washers, M8 hex nuts and f two
CAP screw w/ lock washers, 8 mm flat
washers, and M8 hex nuts on rear rail., then
rotate both feet until they touch the ground,
and tighten the hex nuts against the support
legs to secure the feet.
A
