7
e) The table saw must be secured. A table saw that is not properly secured may move or tip over.
f) Remove tools, wood scraps, etc. from the table before the table saw is turned on. Distraction or a
potential jam can be dangerous.
g) Always use saw blades with correct size and shape (diamond versus round) of arbor holes.
Saw blades that do not match the mounting hardware of the saw will run off-center, causing loss of
control.
h) Never use damaged or incorrect saw blade mounting means such as flanges, saw blade washers,
bolts or nuts. These mounting means were specially designed for your saw, for safe operation and
optimum performance.
i) Never stand on the table saw, do not use it as a stepping stool. Serious injury could occur if the tool
is tipped or if the cutting tool is accidentally contacted.
j) Make sure that the saw blade is installed to rotate in the proper direction. Do not use grinding
wheels, wire brushes, or abrasive wheels on a table saw. Improper saw blade installation or use of
accessories not recommended may cause serious injury.
WARNING Read all safety warnings, instructions, illustrations and specifications provided
with this power tool. Failure to follow all instructions listed below may result in electric shock,
fire and/or serious injury.
CAUTION: This means that if precautions are not heeded, it may result in minor or moderate injury and/or
possible machine damage
WARNING: This means that if precautions are not heeded, it could result in serious injury or possibly even
death.
WARNING:
T
he operation of any power tool can result in foreign objects being thrown into your eyes, which can
result in severe eye damage. Before beginning power tool operation, always wear safety goggles
or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision
Safety Mask for use over eyeglasses or standard safety glasses with side shields. Always use eye
protection which is marked to comply with ANSI Z87.1.
WARNING: If the replacement of the SUPPLY CORD is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
