18
.
.
LEVEL THE FENCE
The fence should be parallel to the table and sit
approximately 2mm above the table’s surface
(so the fence will not scratch the table and a thin
work piece will not get stuck or jammed under
the fence).
To level and adjust the height of the fence:
1. Loosen the hex nut F on the leveling foot G
located under the rear end of the fence
Fig. 14;.
2. Raise or lower the leveling foot until there is
a spacing of 2 mm (approx.) between the
bottom of the fence and the table, then
tighten the hex nut to lock the set- ting of the
leveling foot.
3. If needed, to level the fence, adjust the plastic
set screws E equally, thereby raising or
lowering the front of the fence an equal
amount on either side so as not to undo the
previous perpendicular adjustment Fig. 15
ADJUST & ALIGN RIP FENCE POINTER
Set blade to 90° and raise it to the maximum
height. Move the fence till it lightly touches the
right side of the blade and push down the
locking lever to lock the fence in place.
With the fence locked in place against the blade,
loosen the pointer screws A Line up the
reference line on the pointer with the zero point
on the tape and re-tighten the pointer screws
Fig. 16.
Note: When changing blades, re-align the
pointer with the zero points on the tapes
to account for thinner or thicker blades.
DUST COLLECTOR
There is a 4" dust outlet located on the lower left
of the saw cabinet allowing for the connection to
a dust collection system (not included) Fig. 17.
1. Fit the 4" dust hose over the dust port, (not
included) and secure in place with a hose
clamp.
2. Make sure the hose could not come off.
Note: A tight fit is necessary for proper
performance.
WARNING: ALWAYS TURN ON THE DUST
COLLECTOR BEFORE STARTING THE SAW
AND STOP THE SAW BEFORE TURNING OFF
THE DUST COLLECTOR.
Fig. 14
Fig. 15
Fig. 16
Fig. 17
E
!
！
