Olicom CrossFire 8600, Руководство по эксплуатации

Страница: 129 / 250

113
CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641 Switch Configuration
Setting up a CrossLink
To add a CrossLink between two CrossFire 8600 series switches, determine which
ports to use for the CrossLink. Use at least 2 ports.
The switch treats the port with the lowest number as the primary port. For example,
if a CrossLink consists of ports 8, 11, and 13, the primary port is 8. Broadcast,
multicast, and unknown destination packets are forwarded to the primary port in a
CrossLink. The primary ports of both CrossLinks must be connected to each other.
For example, if a CrossLink links ports 8, 11, and 13 of one device and ports 3, 6,
and 9 of another device, ports 8 and 3 must be connected to each other.
Observe the following precautions and use the following steps to set up a
CrossLink:
•
Disable or disconnect the ports before creating or changing a CrossLink.
•
You must define the CrossLink for both connected CrossFire 8600 series
switches before physically connecting their linked ports. Do not connect the
cables before configuring the switches; if you do, you may create loops.
•
Cable only the ports you have added to the CrossLink menu. If you connect
additional ports between two CrossFire 8600 series switches, a loop results.
1. Disconnect the ports you want to add to the CrossLink, or disable them using
the Port Configuration menu.
2. For each CrossFire 8600 series switch, select the CrossLink Configuration
menu, then choose Add Entry from the menu bar at the bottom of the screen.
3. Enter the ports for the first CrossLink, separated by spaces.
4. Choose Return. (A reset is not required).
5. Repeat steps 1 through 4 for the other CrossFire 8600 series switches.
6. Set the Address Aging Time to the same value for the CrossFire 8600 series
devices.
7. If you disconnected the ports in the CrossLink, reconnect them. If you disabled
them using the Port Configuration menu, use the menu to re-enable them.