Olec Accuprint AP30-5000, Руководство по обслуживанию, Страница: 10 / 138

1-4 94MS36 Rev. F2 S/W Ver 2.06
AP 30 - 5000 printer input
3 phase (Delta) See Figure C 3 wires + ground 480V~ 60 Hz, 18 amp.
3 phase (Delta) See Figure B 3 wires + ground 208/240V~ 60 Hz, 44 amp.
3 phase (Wye) See Figure A 3 wires + n ground 380/415V~ 50 Hz, 24 amp.
Single phase See Figure D 2 wires + ground 480V~ 60Hz, 35 amp.
AP 30 - 8000 printer input
3 phase (Delta) See Figure B 3 wires + ground 208/240V~ 60 Hz, 65 amp.
3 phase (Wye) See Figure A 3 wires + n ground 380/415V~ 50 Hz, 34 amp.
Connecting power
• Remove the lower rear panel of the printer by unscrewing the
5
/
32
" Allen
head screws that attach it. Remove the two screws from the rear that
secure the sliding side doors. Slide both doors to the front.
• Run the main power cord through the round retaining plate on the lower
rear center of the printer.
• Connect the main leads to the 4-position terminal block and connect the
ground lead to the single ground terminal.
• Energize the main power circuit. You should hear the lamp head and
power supply cooling fans go into a cool-down cycle. Ensure that the
voltage select switch on the hinged control panel is switched to the lit
LED.
• Reinstall the lower rear panel. Make sure the air conditioner drain hose
is uncoiled and connected to a drain or allowed to drain into a suitable
container.
• Reinstall the side door securing screw.
• Install the lower front and rear black trim pieces over the forklift channels,
using a
5
/
32
" Allen wrench.
• Connect two 8" exhaust hoses to the outlets on the top rear of the printer.
This will remove the expended heat from the working environment.
!
Cl
PLEASE BE SURE THE DUCT HOSE IS VENTED TO AN
OPEN CHAMBER, AS BACK PRESSURE WILL
GREATLY REDUCE THE COOLING CAPABILITIES OF
THE PRINTER.