21
Assembling Instruction of the Bubbling Column
Inlet tubing
Connector
Outlet tubing
Connector
Head
Screw Cap
with o-ring
Tubing
Connector
O-ring
TUBE E
Filter
Figure 10. Assembling instruction of the Bubbling Column and its parts
1.
Unscrew the red cap with O-ring and the head of the bubbling column from the bottle,
without removing the head from the plug.
2.
Insert filter into the silicone tubing. Connect the silicone tubing to port of the head of
the bubbling column on the inside of the red screw cap.
3.
Insert the filter with the tubing (TUBE E in Figure 10) into the glass bottle, place the o-
ring on the lip of the bottle neck and then screw the cap on.
Cables connection.
Refer to Figure 11 in order to connect the cables to Control Unit.
1.
Connect the base of the incubation chamber, red labeled, to the port labeled ‘Heater 1’
on the rear panel of the Control Unit (see Figure 11)
2.
Connect the lid of the incubation chamber, yellow labeled, to the port labeled ‘Heater 2’
on the rear panel of the Control Unit (see Figure 11).
3.
Connect the humidifying module heater, green labeled, to the port labeled ‘H.M.’ on the
rear of the Control Unit (see Figure 11).
4.
Connect the Objective Heating Collar, blue labeled, to the port labeled “Obj. Heater” on
the rear of the Control Unit (see Figure 11).
5.
NOTE: you need to connect the Serial Cable to the Serial Port on the rear of the Control
Unit ONLY you have purchased the software UNO-TS.
6.
NOTE: The optional accessory Fine Gauge Thermocouple (green) (see paragraph 9.7),
plugs into the green port labeled ‘Reference Temperature’ located on the rear panel of
