Oki OKIFAX 5400, Руководство по обслуживанию

Страница: 69 / 448

T.F.
No.
Item Specifications Default
40838301TH Rev.1 2 - 23
Table 2.9.1 (3/6) Service Personnel Initial Settings
Echo Protection
Ignore 1st DIS
CED-DIS timer
Tone for echo
OFF
OFF
75 ms
OFF
ON
ON
1.5 sec
ON
(TF-12 table)
11 Long document SCAN
12 Tone for Echo
13 MH only
14 High-speed modem rate
15 T1 (TX), timeout value
16 T1 (RX), timeout value
Switches the function of transmitting long-size
document (more than 380 mm).
ON : Unlimited (1500 mm)
OFF : 380 mm.
Switches the function to apply to poor lines with
echo in overseas transmission, etc.
ON: Enables
OFF: Disables
Switches the function of limiting image compres-
sion only to the MH codes.
ON : Coding scheme is MH only. When the
receiving image data is affected by
noise on the telephone line.
OFF : Any of MH, MR and MMR.
Specifies the modem’s starting speed, 33.6K,
28.8K, 14.4k, 9.6k, or 4.8kbps.
Note: 33.6 kbps (V.34) operation is available
when V.34 optional Modem board is
installed and serviceman set enable.
T1 (TX) is a time to detect up to 3 flags of DIS sent
from a called fax machine.
Registers the time duration (in seconds) for
which the fax waits for the remote station’s
answer.
This timer starts when the last dialled digit has
been sent in the automatic transmission mode.
* Selects the 3 digit timer
010 to 255 sec selectable.(in one second
steps)
T1 (RX), timeout value (later)
Registers the time duration (in seconds) for
which the fax waits for the remote station's
answer of individual country's specification. T1
timer starts after the DIS is transmitted. If T1
times out, the fax disconnects the line.
* Selects the 3 digit timer
010 to 255 sec selectable. (in one second
steps)