OHTAKE OM-26M, Руководство по эксплуатации

Страница: 24 / 44

－
23
－
７－５．
Replacing and Adjusting the Brush
Turn OFF the power switch before starting replacement and
adjustment.
７－
4
．
Replacing the Passing Plate
Turn OFF the power switch before starting replacement and
adjustment.
Use the passing plate, rail and escaper that correspond with the di-
ameter of the screws to be used.
Remove the passing plate. Do not lose the attached bolts. Using
bolts other than those supplied with this machine may result in a
malfunction.When installing, use the half-press on both sides of the
passing plate as guides.
Refer to page 13
『
5-7 Check and adjust the passing plate
』
for
adjustment.
If the brush is too worn to sweep screws off of the rail, replace it.
・
Turn ON and OFF the power switch in order to set the brush
bristles facing to the left and detach the brush assembly.
・
The brush assembly can be disassembled as shown in the figure
on the right.
・
For assembly, reverse the disassembling procedure.
・
After completing the assembly, check that the front part of the
brush doesn't come in contact with the passing plate. The ideal
clearance is 0mm.
・
For adjustment, refer to "5-3. Adjusting the brush height".
The part number of the brush assembly is TPO00908.
Remove the passing
plate bolts and rotate
the passing plate in
order to remove it.
Passing plate
Passing plate
attaching screw
Brush assembly
attaching screws
Passing plate
Brush
When the brush is operating, it
should not come in contact with the
passing plate.
Hexagon socket
head screw M2.6X10
Spring washer
Plain washer
Brush bracket
Brush holding plate
Brush
(Front)
(exploded view)