OHTAKE OM-26M, Руководство по эксплуатации

Страница: 21 / 44

－
20
－
Position one of the spring arms under the plain washer
of the spacer screw and the other arm on the stopper tab.
Attach the escaper and the escaper guide-right.
Assemble the escaper loosely as it will need adjusting later.
Note that the stopper should not be on the escaper.
The stopper should be laying flat against the escaper guide-left. If it
is not laying flat, bend it gently by hand to adjust it.
③
Adjust the escaper notch position.
Turn the power switch ON while covering the sensor light axis with a
small piece of paper.
When the power is ON, the screw sensor LED lights up and the
escaper rotates around, to the starting point. (Reference point run.)
When the escaper stops, loosen the fixing screws and adjust the
escaper by hand so that an escaper notch and the rail groove align.
Tighten the escaper fixing screws.
The pick up site notch
matches with the escaper
notch.
Position the spring arm under the
plain washer of the spacer screw.
The stopper should
not be on the escaper.
The stopper should
lay flat against the
escaper guide-left.
Escaper fixing screws