OHTAKE OM-26M, Руководство по эксплуатации

Страница: 35 / 44

－
34
－
Trouble Cause Corrective Measure
A screw has fallen into the rail
groove.
・
Screws with a smaller diameter than the
specified rail size were loaded.
・
Screws with a shorter total length than
the rail groove width were loaded.
・
Use screws with the specified nominal
diameter and length.
・
No corrective measure is available.
Consult our service section.
The flow on the screw rail is not
working properly.
・
The clearance between the holding
plate and the head of the loaded screw
is low.
・
Screws with a spring washer having
one increment smaller than the
specified nominal rail size were loaded.
・
The rail is oily or dirty.
・
The rail does not vibrate.
(A screw is caught in the gap.)
・
The motor is worn malfunctioning.
・
Adjust the holding plate.
Adjust the vibration.
If, after following the instructions
written above, the machine still does
not function properly, consult our
service section.
・
Clean the rail.
・
Remove the screws caught in the
clearance.
If there is no screw that is caught,
consult our service section.
・
Check that the vibration level is
properly adjusted.
・
Replace the motor.
[Part No. : NSB 09182 #05]