OHTAKE OM-26M, Руководство по эксплуатации

Страница: 22 / 44

－
21
－
④
Check the position of the parts for smooth delivery of the screws.
Check that the clearances between the outside edges of the rail and the
escaper guide-right and left are almost even.
If they are in contact, the screws cannot be delivered. If there is too
much clearance, on either side, screws may fall into the machine.
At this time, make the top surface of the escaper even to or 0.1
～
0.5mm lower than the rail surface. If it's too high, a screw won't
enter an escaper notch. If it's too low, a screw will not enter a notch
properly. If any adjustment is required, remove the cover, loosen the
escaper bracket attaching screw and move it up or down, left or right
and tighten the screw.
After adjustment, turn the power switch ON in order to make a
reference point run and check that an escaper notch and the rail
groove align.
After, remove the paper blocking the sensor's optical axis and the
escaper will start rotating. Check that all 4 notches of the escaper, in
each rotation stop, aligns with the rail groove.
After checking and adjusting each component, do an
operational check with screws loaded.
If any abnormality is found, make the said adjustments once again
in addition to the rail vibration and front/rear
position adjustments. When installing the cover, take care not to
catch or pinch the wires.
The surface of the escaper
should be slightly lower than
the surface of the rail.
E scaper bracket attaching bolt
There must not be any contact
between the rail, the escaper
and the escaper guide.
Pick up site notch