OHTAKE OM-26M, Руководство по эксплуатации

Страница: 17 / 44

－
16
－
7
．
PARTS ADJUSTMENTS AND REPLACEMENTS
The brush and main motor are consumable parts.
When using a different diameter of screw, the following items must be replaced: rail, escaper and passing plate. These
parts may be ordered separately.
The replacing and adjusting procedures are described on the next page.
When replacing any parts, a fine adjustment is required. Make these fine adjustments by reading the corresponding
contents carefully.
Before replacing any parts, be sure to remove all the screws from the hopper.
６．
MAINTENANCE
A dirty rail groove may interfere with the screw transport speed.
Clean the dirty rail with a soft, clean cloth dipped in alcohol.
If cleaning is difficult, remove the rail from the machine and clean the rail groove.
Refer to the next section under
『
7-1 Replacing the rail assembly
』
for replacing.
Before removing the rail from the machine, be sure to turn off the power supply and take the screws out of the hopper.
If there is any dirt or a flaw in the rail groove that may cause an impediment in use,
we recommend the user to replace the rail.