OHTAKE OM-26M, Руководство по эксплуатации

Страница: 28 / 44

－
27
－
・
Release longer end of the stopper spring from the spring
holder, and unfasten the spring end nut. When unfastening
the end nut, please be cautious that the washer underneath
may spring out.
・
Disassemble the plain washer, stopper spring, and stopper in
order.
・
Install the new stopper, stopper spring, and washer in order.
Fasten the end nut while holding down the plain washer in
place. During this process, please be careful not to allow the
spring to become trapped by spring end nut and plain
washer.
・
When the stopper spring assembly is completely fastened, fix
the longer end of the spring onto the spring holder
(as shown on right).
Please check if the stopper can move freely, and that the
bottom edge of the stopper is completely aligned and parallel
with escaper guide.
Turn OFF the power switch before replacing.
7
-
8
．
Replacing the stopper
The stopper is a consumable part. When the stopper is worn-off or
damaged in shape, replacement is necessary to ensure proper machine
operations.
（
When stopper is being replaced, the escaper guide does not need to be
removed from the machine.
）
Part number: E-Stopper TPO-00512
Stopper
Spring holder
Spring end nut
Escaper guide-left
Stopper spring
Plain washer
Shorter arm of the spring should be placed to the left
side of the bent edge of the stopper.
Longer arm of the
spring should be fixed
underneath the plain
washer.
Please make sure the tip of the stopper does not touch the
escaper, as it may interfere with the escaper's
rotation.
If the end of the stopper is too close or too far from the escaper,
please adjust the bent joint of the stopper where it makes contact
with the spring holder, with a pair of long-nose pliers, so that the
front of the stopper rests at the proper position.
Spring holder
Joint in contact with the spring holder,
where adjustments can be made. (to
adjust position of the stopper)
○
×
×
Stopper touching the escaper
Stopper being too far from the escaper