OHTAKE OM-26M, Руководство по эксплуатации

Страница: 11 / 44

－
10
－
５－３．
Adjusting the brush height
Load the screws into the scooping hopper, turn ON and OFF the
power switch so that screws are alligned into the rail groove.
・
Turn ON and OFF the power switch in order to set the brush to the
left as shown in the figure on the right.
・
Move the brush by hand to check that the screws, in the rail
groove, are in slight contact with the brush bristles and if needed
make the necessary adjustments.
・
When the brush height is too high or low, this will have an adverse
effect on the screw allignment and transport.
・
If any adjustment is necessary, loosen the brush height adjusting
bolt to adjust the brush height.
・
If the plastic portion, at the front of the brush, comes into contact
with the passing plate, loosen the brush assembly mounting screw
and move the brush assembly back so there is 0 mm clearance.
・
Turn ON the power switch to check that the brush operation is
normal.
Turn OFF the power switch before starting replacement and
adjustment.
Brush
Loaded screws
Brush height adjusting bolt
Move the brush by hand to check that the screws, in the
rail groove, are in slight contact with the brush bristles
and make adjustments if necessary.
Turn On and Off the power switch to put the brush
bristles in a horizontal position towards the left side.
Brush assembly
attaching screw