68
PAS 2200
EN
TROUBLESHOOTING
• If the device should stop working properly, first check whether you are able to cor-
rect the problem yourself. If you are not, contact the customer service department.
Do not try to repair a faulty device yourself!
Problem
Possible cause /solution
The device does not work.
• Is the ON/OFF switch in the OFF position ?
Move the ON/OFF switch to
MIX
or
EXT
.
• Is the selection made on the function switch the same as
that on the ON/OFF switch ? The switch positions of the
two switches must match (
MIX
or
EXT
)
• The mixing container lid is not placed on correctly. Open
the mixing container lid again and insert the rear tab into
the recess on the motor unit. Lower the lid and close it so
that the locking clip locks in place. The pin on the back
edge of the lid must activate the safety switch in the mo-
tor unit.
• Is the plug inserted in the mains socket correctly ?
• Is the mains socket defective ? Try another mains socket.
• Check the fuse of your mains connection.
Kneading spiral does not
rotate evenly or the pasta
dough is expressed unevenly/
with interruptions from the
pasta attachment.
• Too much pasta dough. Switch the device off and pull the
mains plug from the mains socket. Remove some pasta
dough from the mixing container and then continue the
kneading process.
• The pasta dough is too dry. Add some liquid, e.g. water or
olive oil, to the dough.
The locking cannot be
undone.
• Move the function switch and then the ON/OFF switch to
the
MIX
position and then allow the device to run for a
few seconds. Move the ON/OFF switch to the
OFF
position
and then try to undo the locking ring again
The pasta dough only
emerges very slowly from the
outlet openings of the pasta
attachment.
• Check the consistency of the dough. The dough must not
be too moist or too dry. The dough should have a granular
consistency with roughly pea-sized little lumps of dough.
Add more water or more flour to the dough if necessary.
The connecting piece cannot
be inserted.
• Check whether any dough residues have become stuck to
the connecting piece or on the mixing container. If they
have, remove them and then try again.
• The connecting piece must be inserted in such a way that
the circular mark on the connecting piece is opposite the
upper circular mark on the mixing container. Only then
can the connecting piece be inserted into the mixing con-
tainer up to the limit stop and then be locked by turning it
clockwise.
