OHAUS Ranger Count RC1P1502, Инструкция по эксплуатации

Страница: 7 / 40

Ranger™ Count 3000 Series EN-5
TABLE 3-1. Cont.
Button
Primary
Function
(Short Press)
0-9
Enter numeric
values on the
display.
Enter decimal
point (
.
) on the
display.
C
Clear the last
character
from the
display.
Tare
Perform a
tare
operation.
Sample
Display/
Start
new APW
Secondary
Function
(Long Press)
Switch between
scale 1 and
scale 2
(only available
if second
platform is
connected)
+/-
Switch
between
positive and
negative
value
Notes:
1
Short Press: Press less than 1 seconds.
2
Long Press: Press and hold for more than 2 seconds.
TABLE 3-2. LCD Symbols
Item Description Item Description
1 NET symbol 10 Low Sample Weight Symbol
2 Center of Zero symbol 11 Auto Optimization Symbol
3 Negative symbol 12 Dynamic symbol (not used)
4 Stable weight symbol 13 Battery charge symbol
5 Preset Tare, Tare symbols 14 Pound, Ounce, Pound:Ounce symbols
6 Pointer symbols 15 Percent symbol (not used)
7 Accumulation symbol 16 Kilogram, gram symbols
8 Calibration / Menu Mode symbol 17 Pieces symbol, tonne symbol (not used)
9 Low Average Piece Weight Symbol 18 Scale symbol (only shown when 2
nd
platform is connected and turned on)
Notes:
The APW Lo symbol will be lit if the APW value is lower than minimum recommended APW (refer to table 7-1 for
minimum APW).
The Wt Lo symbol will be lit if the sample weight is lower than minimum recommended sample weight (refer to
Table 7-1 for minimum sample weight).
1
7
8 10
11 12 13
14
15
Figure 3-2. LCD Displays
.
2
3
4
5
6
9
16
17
18
Piece Weight
Weight