OHAUS Ranger Count RC1P1502, Инструкция по эксплуатации

Страница: 5 / 40

Ranger™ Count 3000 Series EN-3
2.5 Connecting Power
AC power is used to power the scale when battery power is not needed. First, connect the AC
power cord (supplied) to the power input jack then connect the AC plug to an electrical outlet.
2.5.1 Battery Power:
The scale can be used on AC power immediately. Allow the battery to charge for 12 hours
before using the scale on battery power. The scale will automatically switch to battery
operation if there is a power failure or the power cord is removed. With AC power, the scale
is constantly charging, so the battery charge indicator (see item 13 in figure 3-2) will remain
lit. The scale can be operated during charging, and the battery is protected against
overcharging.
During battery operation, the battery symbol indicates the battery charge level. The scale
will automatically turn off when the batteries are fully discharged.
For maximum operating time, the battery should be charged at room temperature.
TABLE 2-1
Symbol Charge Level
0 to 10 % Remaining
11 to 40 % Remaining
41 to 70 % Remaining
71 to 100 % Remaining
Notes
:
When battery symbol blinks fast, approximately 30 minutes working time is left.
When [
lo.bat
] is displayed, the scale will shut off.
Charging the scale must be performed in a dry environment.
CAUTION: Battery is to be replaced only by an authorized Ohaus service
dealer. Risk of explosion can occur if the rechargeable battery is replaced
with the wrong type or if it is not properly connected. Dispose of the lead
acid battery according to local laws and regulations.
Figure 2-3B. Connect the AC power
plug to the proper AC supply.
Figure 2-3A. Connect the AC power
plug to the input jack on the back of
scale.