OHAUS Ranger Count RC1P1502, Инструкция по эксплуатации

Страница: 17 / 40

Ranger™ Count 3000 Series EN-15
4.3 Setup Menu
Enter this menu to set scale parameters. Default settings are in
bold
.
Reset
[ reset ]
Reset the Setup menu to factory defaults.
NO = not reset
YES = reset
Dual Scale [
d.scale
]
Set the status of the second scale input (Scale 2).
OFF = disabled
ON = enabled
Cap2 [
CAP2
]
Set the capacity of Scale 2.
1…9999
Grad2 [
GrAd2
]
Set the readability of Scale 2.
0.00005…0.5
Power on unit
[ pwWr.UN ]
Set the unit of measure displayed at startup.
AUTO = last unit in use when turned off
kg = kilograms
g = grams
lb = pounds
oz = ounces
lb:oz = pound ounces
Zero Range
[ ZErO ]
Set the percentage of scale capacity that may be zeroed.
2% = zero up to 2 percent of capacity
10% = zero up to 10 percent of capacity
Auto Opt [
A.OPt
]
Set the Automatic Optimization.
OFF = disabled
ON = APW automatically optimized
Reset:
no
, yes
Dual Scale:
off
, on
Cap2:
1
…9999
Grad2: 0.00005…0.5
Power on unit:
auto
, kg, g, lb, oz, lb:oz
Zero Range: 2%,
10%
Auto Opt: off,
on
Auto Tare: on,
off
, on-acc
Beeper Opt: off,
on
Beeper Signal:
off
, accept, under, over, under-over
Beeper Key:
off
, on
Accumulation: off, auto,
manual
End Setup: Exit menu