Adventurer SL
EN-5
2.2.2 Assembly of Models AS64, AS214, AS313
2. Carefully remove each of the five (5) glass draft shield sections from its
packing. You will note that two (2) of these are plain, two (2) contain
handles, and the other is set in a plastic frame. These sections or panels
comprise the front and back, side doors, and top (respectively) of the Draft
Shield. The Draft Shield contains four (4) upright posts and two (2) cross
members which act as a framework for insertion of the panels.
1. Insert the Platform Assembly on the Cylindrical Cone in the center of the
balance.
3. Install the plain glass panels to form the front and back of the draft shield.
• Select a plain glass panel and insert the bottom edge of the glass in the
recessed slot in front of the balance, as shown.
• As you push the top edge of the glass side panel toward the cross-
member, reach inside the top of the framework and depress the small clip
located under the cross-member.
• Release the clip when the glass panel is fully inserted.
• Press the glass panel into the framework until you feel the glass slip into
place.
• Repeat these steps to install the other plain glass panel on the opposite
side of the framework.
Close-up of clip under top of
Draft Shield framework
Models AS64, AS214, AS313
Plain Glass
Front Panel
Platform Assembly
Cylindrical Cone
Recessed Slot
Clip under cross-member
on top of Draft Shield
framework
