EN-16
Adventurer SL
3.4.3 Changing Settings
Settings may be changed by performing the following steps:
ENTER THE MENU
With the balance turned off, press and hold
Yes
until MENU appears on the
display. Release the button to display Calibrate (CAL) on the first level of the Menu
(See Section. 3.4.1 Menu Structure). Each Menu Item on this level represents a
Sub-menu.
SELECT A SUB-MENU
To select the displayed Sub-menu and show the first Menu item, press
Yes
. To
move to the next Sub-menu item, press
No
.
SELECT A MENU ITEM
To select the displayed Menu item and show the Setting, press
Yes
.
To move to
the next Menu item, press No
No
No
No
No.
SELECT THE SETTING
To select the displayed Setting, press
Yes
. To move to the next Setting, press No
No
No
No
No.
EXITING THE MENU
When END Sub-menu is displayed, press
Yes
.
Note
: Press and hold
No
at any time to exit quickly.
3.5 Balance Settings
Refer to Section 3.4 (above) for information on navigating the Menu.
3.5.1Calibration Sub-menu
The Calibration Sub-menu is used to calibrate the balance for accurate weighing.
Adventurer
SL balances may be calibrated in two ways: Span Calibration or Linearity
Calibration.
3.5.1.1 Span Calibration
Span Calibration is the basic method used to set the balance's weighing range
using two weight values: zero and a weight between 50% and 100% of the capacity
of the balance. Span Calibration is required before the balance is used the first time,
and every time the balance is moved to a new location.
To perform Span Calibration:
With the balance turned off, press and
hold
On
until MENU is displayed, then
release the button.
CAL is displayed. Press
Yes
to enter the
Calibration Sub-menu.
