Ocular Robotics RobotEye REV25-ST, Руководство пользователя

Страница: 12 / 27

Basics 9
www.ocularrobotics.com Ocular Robotics Ltd
a) Open the system enclosure by removing the eight countersunk socket screws
from the base.
b) Connect the chosen GigE camera to the C-mount thread on the end of the REV25-
ST unit. A universal camera mount to suit all Allied Vision Technologies cameras
recommended for use with the REV25-ST VISION - STABILIZED product is
supplied with the REV25-ST VISION - STABILIZED System. If a different camera
is chosen and it can’t be used with the mount provided then alternative
mounting arrangements should be provided.
DO NOT allow the camera to be
unsupported on the camera lens.
c) The camera lens should be rotated on the filter thread where it attaches to the
REV25-ST by the minimum amount required to align the body of the camera to
one of the two possible camera mount positions shown in Figure 3.11.
d) Remove two socket head screws in the base of the REV25-ST body in the chosen
position for the attachment of the camera mount (
DO NOT have any more than
two screws removed from the base of the REV25-ST at any time). Place the
camera mount in position and replace the socket screws but do not tighten until
the mount is attached to the camera.
e) Use fasteners appropriate for your camera to fasten the camera to the mount and
then tighten the socket screws attaching the mount to the base of the REV25-ST.
NOTE – The screws fastening the camera to the universal camera
mount must be loosened before adjusting the focus.
f) Attach the internal Ethernet cable from the enclosure camera Ethernet connector
to your GigE camera
g) The two pin connector shown in Figure 3.3 makes 24 VDC available for camera
power connection; a suitable converter from 24V to your camera’s required
voltage will need to be provided.
h) Follow the procedure in Section 3.5.3 to adjust the focus and aperture of the
camera.
i) Replace the base using the eight countersunk socket screws and tension
correctly to maintain the integrity of the seal.
6. Attach power and communications cables as appropriate for your camera.