Mounting the XE–800
WARNING!
The XE–800 contains static-sensitive CMOS components. To avoid
damaging your card and its components:
Ground yourself before handling the card and observe proper ESD
precautions
Disconnect power before removing or inserting a PC/104 or PC/104
Plus
expansion board
Equipment required
To install the XE–800 SBC you will need the following equipment (or equivalent):
XE–800 SBC
+5V power supply – see the
XE–800 SBC power supply requirements
section.
You might also need an XE–800 ATX power cable, part #6537.
A device with an operating system. The device could be a CompactFlash, hard
disk, or CD ROM. The operating system can be Windows NT, Windows CE.net,
Linux, QNX, or DOS.
Note: Windows 2000 and Windows XP/XP
Embedded will run with known issues, however, new driver
development is not supported by the CPU manufacturer.
PS/2 style keyboard
SVGA monitor
2 mm VGA-12 Cable, part #6392
VTC-20F Cable, part #4866 (for serial console)
Null modem adapter, #2740 (for serial console)
Windows HyperTerminal or equivalent terminal emulation software (for serial
console)
Your PC (for serial console)
Hardware components required to mount the XE–800 SBC (included):
9 threaded hex standoffs (4–40 x ¾”)
9 screws (4–40 x 3/16”)
9 internal star lock washers (#4)
9 nuts (4–40)
Refer to the XE–800 SBC component diagram, figure 2–1 on page 18, for the
location of various connectors, and to the mounting hole diagram, figure 2–3 on
page 20, for mounting the XE–800 SBC system.
23
Содержание XE-800
Страница 18: ...Figure 2 1 XE 800 SBC component diagram top 18 ...
Страница 19: ...Figure 2 2 XE 800 SBC component diagram bottom 19 ...
Страница 20: ...Figure 2 3 XE 800 SBC dimensions 20 ...
Страница 89: ...MOV AX 0fb0bh MOV DX 0ffffh INT 17h MOV aData AL if aData 1 printf U1 jumper is ON n 89 ...
