EXPLORE
E6 & E7
.
2021 INSTALL & OPERATION MANUAL
20
5.3 LIGHT CARTRIDGE REMOVAL
– SINGLE MOUNTING TUBE
Before proceeding with this operation, you MUST seek permission from either the manufacturer or your
OceanLED representative.
DO NOT remove the light cartridge from the mounting tube during installation. The light cartridge MUST stay
fitted inside the mounting tube throughout the installation process to avoid the introduction of potential
contaminants that may damage the product.
Additional Tools required not supplied by OceanLED
•
Allen key (2mm).
1. If the vessel is in water check that the front glass is present and intact. Never remove a cartridge with the
vessel in water if damage to the glass lens is suspected.
2. Turn power off and unplug all the connectors on the back of light.
3. Remove the locking ring from the mounting tube.
4. Undo one of the six screws from the back of the light cartridge to allow the Explore Removal Tool to be placed
(see image below).
To ease the removal process, another screw can be removed to act as a breather.
5. Place the Explore Removal Tool under the head of the undone screw making sure that the screw engages
with the slot on the tool, then fasten the screw in a clockwise motion. By tightening down the screw the light
cartridge will be pulled out of the mounting tube.
Locking
Ring
Screw
