EXPLORE
E6 & E7
.
2021 INSTALL & OPERATION MANUAL
21
6. Finish pulling the light cartridge out by hand with the help of the tool to fully remove it from the mounting tube.
5.4 LIGHT CARTRIDGE REMOVAL
– EXTENDED MOUNTING TUBE
Before proceeding with this operation, you MUST seek permission from either OceanLED or your OceanLED
representative.
DO NOT remove the light cartridge from the mounting tube during installation. The light cartridge MUST stay
fitted inside the mounting tube throughout the installation process to avoid the introduction of potential
contaminants that may damage the product.
Additional Tools required not supplied by OceanLED:
•
T-Handle Allen key (2mm) 80mm length.
1. If the vessel is in water check that the front glass is present and intact. Never remove a cartridge with the
vessel in water if damage to the glass lens is suspected.
2. Turn power off and unplug all the connectors on the back of light.
3. Remove the locking ring and the compression tube from the mounting tube.
4. Undo and remove one of the six screws from the back of the light cartridge to ease removal.
5. Loosen the other 5 screws by the same height (approx. 15-20 full rotations of the Allen key) without removing
them.
6. Insert the Explore Extended Removal Tool into the mounting tube ensuring the cut-outs in the tool align with
the screws. Twist the tool to align.
Not engaged
