EXPLORE
E6 & E7
.
2021 INSTALL & OPERATION MANUAL
19
5
Operation / Maintenance
5.1 OPERATION
Switch Control
The Switch Control mode allows the user to switch between colours and strobe modes using a push switch.
The sequence for the Explore E6/E7 Dual White/Blue is a closed loop as follows:
1. Solid White
2. Solid Blue
3. Fade White / Blue
4. Strobe Blue
5. Strobe White
6. Strobe White / Blue
7. 50% White and 50% Blue
After step 7 the next button press will reset the sequence back to step 1.
The sequence for the Explore E6/E7 Colours DMX is a closed loop as follows:
1. Solid Chosen Colour
2. Strobe Chosen Colour
3. Colour Cycle
If during the colour cycle (step 3), the switch is pressed again, the cycle will stop and the current colour will be stored
and remain static (i.e. go back to step 1 in the sequence, with a new stored chosen colour).
DMX Control
Please refer to the purchased DMX Controller for details about how to use it. For 3
rd
party DMX control see section
4.5.
5.2 MAINTENANCE
Marine growth can build up quickly on the light and can reduce the performance in just a few weeks.
To help prevent this, all OceanLED lights have been coated with a specialized Tritonium® coating which makes the
surface of the glass lens a non-stick layer. Lights should be cleaned with a boat brush or similar biweekly, or as needed
to keep the lens of the light clean.
Growth varies greatly around the world and maintenance is imperative to the proper operation and longevity of the
product. If heavy fouling occurs, barnacles can be removed from the lens using a plastic scraper and moderate pressure
under water. If cleaning the lens while the boat is out of the water, wet the lens before scraping. Never scrape or try to
remove barnacles from a dry lens.
Never use high pressure jet wash to clean the lens / bezel.
