Chapter 4 : Preparing for a job
43
AP-75037, Rev. 1.1, 24/04/2006
4.1 INTRODUCTION
The procedures needed before using the printer are explained below.
4.2 CONNECTING THE POWER CABLE
Warnings :
Warning :
•
Make sure that the enclosed power cable is used. Use of a different cable
may result in electric shock or fire.
•
Do not use a damaged power cable. Doing so may result in electric shock or
fire.
•
The disconnect device is the plug on the power supply cord.
Caution :
•
Be careful of the following when handling the power cable.
o
Do not make any modifications to the power cable.
o
Do not place anything heavy on the power cable.
o
Do not bend, twist, or pull the cable.
o
Do not wire the cable near equipment that generates heat.
Warning :
•
Do not attempt to plug in electrical plugs with wet hands. Doing so may
result in electrical shock.
•
Be sure to use the specified voltage (AC 100V-120V/220V-240V). Otherwise,
electrical shock or fire may occur.
•
Use electricity directly from a power outlet (AC 100V-120V/220V-240V). Do not
put many loads on one electrical output. Otherwise, heat may be generated
and cause fire.
•
Be sure to use an outlet with an earth terminal, and use the terminal
correctly. Otherwise, electrical shock or fire may occur.
•
Do not connect earth cables in the following areas :
o
Gas pipes. Doing so may cause fire or an explosion.
o
Earth terminals for telephone lines or lightning rods. Doing so may
cause a large flow of voltage if lightning occurs.
o
Water pipes or faucets. If there is a plastic part in the pipe, the
earthing will not work correctly.
Содержание CS9065
Страница 1: ...Océ CS9065 Océ CS9090 User Guide Eco Solvent ...
Страница 12: ...Chapter 1 Safety Instructions 12 AP 75037 Rev 1 1 24 04 2006 No Type 1 2 3 4 5 ...
Страница 24: ...Chapter 2 Product Overview 24 AP 75037 Rev 1 1 24 04 2006 This page is intentionally left blank ...
Страница 78: ...Chapter 4 Preparing for a job 78 AP 75037 Rev 1 1 24 04 2006 This page is intentionally left blank ...
