Oce Arizona 400 Series GT, Руководство пользователя

Страница: 222 / 270

Note:
When you print on the RMO, if the media width entered is less than 1067 mm (3.5 ft)
the standard nozzle check will not fit across the media. In this case, if the Nozzle Check
icon is selected from the Print Job Control command toolbar, the narrow version (Nozzle
Check Narrow 886.5 x 214.7 (2.9 x 0.70 ft)) is automatically added to the print queue.
1.
Place a piece of Océ I/O paper on the printer table (or use the RMO, if available).
2.
Select the Nozzle Check icon at the right end of the Command Toolbar to place the
nozzle check into the Active Print Job list (you can also add a Nozzle Check to the active
print list when you select it from the Special Prints module).
3.
Confirm media thickness.
4. Activate the table vacuum.
5.
Push the printer Start button to begin the print.
6.
Print an image to make sure there is no banding or other print quality issues.
How to Evaluate a Nozzle Check
1.
The Magenta section of the Nozzle Check print example shown in the figure below indi-
cates that multiple nozzles are out.
Chapter 12 - Printer Maintenance 222
Printhead Maintenance