Océ imagePRESS C7010VPS series, Техническое руководство

Страница: 23 / 362

Engine specific media attributes
Registration: Front & Registration: Back:
• X shift (0.1 mm)
To make adjustment to enable printing with correct alignment of paper and image. Value: -50.0
mm to +50.0 mm, step: 0.1 mm, default: 0.0 mm
• Y shift (0.1 mm)
To make adjustment to enable printing with correct alignment of paper and image. Value: -50.0
mm to +50.0 mm, step: 0.1 mm, default: 0.0 mm
• X elongation (0.01%)
To make adjustment (enlargement/reduction) of image size in feed direction. Value: -1.00 to
+1.00%, step: 0.01%, default: 0.00%
• Y elongation (0.01%)
To make adjustment (enlargement/reduction) of image size perpendicular to feed direction.
Value: -1.00 to +1.00%, step: 0.01%, default: 0.00%
• Skew
To make adjustment of image skew at left leading edge and the left trailing edge with respect
to the feed direction. Value: -2 to +2, step: 1 default: 0
Back side lead edge alignment auto correction:
• To make automatic adjustment for change in length of media for backside image. Value: On/
Off, Default: Off
Finishing:
• Saddle stitch position adjustment (mm)
Adjust the saddle stitch position for saddle stitch function of Saddle Finisher. Value: -2.00 to
+2.00 mm, default: 0 mm
• Saddle stitch fold position adjustment (mm)
The fold placement is adjusted by using the saddle stitch function of the Saddle Finisher.
Value: -2.00 to +2.00 mm, default: 0 mm
• Saddle fold position adjustment (mm)
The fold placement is adjusted by using the saddle fold function of the Saddle Finisher. Value:
-2.00 to +2.00 mm, default: 0 mm
• Punch hole position adjustment (mm)
Fine-adjust the punch hole position. Value: -2.00 to +2.00 mm, default: 0 mm
Advanced settings
Decurl:
• Output face down
Adjust the paper curl level. Value: -15 to +15, default: 0
• Output face up
Adjust the paper curl level. Value: -15 to +15, default: 0
Gloss adjustment:
• Switch the fixing temperatures and determine if the paper goes through only the primary
fixing unit or through both primary and secondary fixing units. Value: -2 to +2, default: 0.
Increased values: glossier
Pick up air:
• Adjust the amount of air used by the separation in the POD deck. Value: -5 to +5, default: 0
Separate:
• Adjust the separation of paper from decks. Value: -5 to +5, default: 0
Image clear level adjustment:
• Improve "Intermediate Transfer Belt" (ITB) cleaning performance. Value: -10 to +10, default: 0.
An increased value results in higher ITB cleaning.
Media selection
Chapter 2 - PRISMAsync 23
imagePRESS C7010VPS series v2.2