nVent.com
|
19
Raychem-AR-H
58686
-NGC
40
DemoUnit-EN-
1805
Step
4
–
Config Button
Click on the Config button. The screen below will appear. This screen has the Basic Settings for Temperature, Electrical and Device
Information. The first screen that appears is Temperature.
Step
5
–
Temperature -General Settings – Tag Name
The General section allows you to enter a new Tag name and configure Control Temperature settings. To enter a tag name click where the
tag name is shown. This will open the keyboard for entering the new tag name.
• Enter a new tag name
Step
6
–
Temperature – Basic Settings – Control Temperature
• Click on the Control Setpoint field. A numeric keypad will open allowing you to change the setpoint.
• Enter in a new setpoint of
90
°C.
• The High Alarm is disabled by default. Enable the high alarm by checking this box.
• Change the High Alarm to
110
°C.
• Change the Low Alarm to
50
°C.
• Click on the Apply button to save these changes.
IMPORTANT:
If you try to exit the Config screen without clicking on the Apply button a warning message will appear asking you
if these changes are to be saved.
