NUOVA ELETTRONICA DSP LASER, Инструкция по эксплуатации

Страница: 46 / 66

DSP LASER
42 DSPLSR01EN
Fig. 13.3 Positioning with respect to the axis of the tool
•
The lower horizontal surface for the protection of TX and RX is perpendicular to the
bending surface along all the adjustment stroke of the supports.
Fig. 13.4 Transversal adjustment with respect to the bending surface
•
The lower horizontal surface for the protection of TX and RX is parallel to the upper
table, so that the value of the safety distance is constant for all the length of the upper
tool.
Fig. 13.5 Adjustment longitudinal with respect to the bending line
The designing of the mobile support of the device must be such not to create entrapment
points during the closing and opening movement of the press.
Additional protection must be adopted to eliminate the dangers which can be generated by
DSP LASER (for example, between DSP LASER and the fixed parts of the press) and to
allow the access to the dies area passing through the front area.
The device must be protected against the accidental crashes which could damage it or
modify its set adjustment.
WRONG CORRECT WRONG
WRONG CORRECT WRONG
TX
RX TX RX TX
RX
90°