NUOVA ELETTRONICA DSP LASER, Инструкция по эксплуатации

Страница: 45 / 66

DSP LASER
DSPLSR01EN 41
•
The distance between the front part of TX and RX and the basement of the press is
greater than or equal to 100 mm with the purpose to avoid the squashing of the hand.
The adjustment of the supports takes place only along the vertical axis of the press, in
parallel direction to the bending surface.
•
The movement of the supports is such to allow:
o
the correct use of the tools, with minimum and maximum height, signalled by the
manufacturer of the press.
Check
Install the minimum height tool; bring the supports of TX and RX as high as
possible and lock them in this position, check the beam is interrupted by the tool.
Install the maximum height tool; bring the supports of TX and RX as down as
possible and lock them in this position, check the beam is not interrupted by the
tool.
o
the unassembly of the tools without requiring the unassembly of the devices and/or
supports (e.g. possibility to extract the tools with the TX completely lifted).
•
The locking of the support, once adjusted, is safe against the accidental loosening
Crashes and vibrations
Use all the possible precautions to reduce the vibrations of the machine. Protect
the device and the supports with material protections in such a way to avoid
crashes.
13.3.4. Installation
The containers of TX and RX are provided with three threaded holes for the fixing to the
machine, as reported in figure 13.1. Then fix TX and RX to the supports by means of three
6MA screws, screwing them in the proper seats present in the equipment.
Caution:
Be sure that the screws are tighten in such a way not to be loosen by
the vibrations of the machine. The torque strength of the screws
must not be less than 1.96 N*m (20 kg
f
*cm).
The devices must be fixed to the supports in such a way that:
•
The central vertical protection surface of TX and RX is not 2 millimetres beyond the
axis of the tool towards the rear part of the press.