NUOVA ELETTRONICA DSP LASER, Инструкция по эксплуатации

Страница: 57 / 66

DSP LASER
DSPLSR01EN 53
Adjust the height of TX, moving the support in vertical direction, in such a way that the
LOWER EDGE OF THE LASER EMISSION coincides with the line pointing out the STOP
SPACE of the machine, as in Fig. 14.4. In this example, the lower edge of the laser
emission is place on the line pointing out a stop space whose value is 13mm. For each
machine, the corresponding stop space must be known. If this datum is not known, first
place the lower edge of the laser emission coinciding with the line pointing out the highest
value (19mm) of the STOP SPACE.
Fig. 14.2 Cross view Fig. 14.3 Front view
Then adjust TX along the surface (transversal to the bending surface) acting on the screws
fixing TX to the support in such a way that the central vertical surface of the detection area
coincides with the STOP FOR THE HORIZONTAL POSITION and the edges of the
detection area are contained within the two surfaces defined by the two vertical lines and
marked by
R and F , as in Fig. 14.4. Then lock TX in this position.
TX RX
UPPER TOOL
MOBILE TOOL HOLDER
LOWER TOOL
TEST AND
POSITIONING
INSTRUMENT
TX
A B B1