NuAire LabGard NU-581-400, Руководство по эксплуатации и обслуживанию

Страница: 39 / 107

OM0302
Rev 2/December 2020 Page 39 of 107
7.1.1 Manual Decon
1. Disconnect power to the cabinet. Remove screws at each upper side of the control center and allow the control
center to rotate down, resting on the safety straps. Disconnect electrical connectors on left and right sides. (Be
sure to note the location of the supply and exhaust sensor wires before disconnecting them from the main board).
Remove control center by disconnecting safety straps and moving control center up and out.
2. Remove the top front decorative panel via top/front fasteners.
3. Remove window assembly (both frame and window, either being manual, sliding, or automatic) via the upper and
lower fasteners (Refer to BCD-12281). At this point, the sliding window assembly can be removed.
4. Remove exhaust sensor shrouds.
5. Remove the diffuser screen (some methods of manual decon process have been shown to oxidize the diffuser) and
gasket around perimeter of workzone.
6. Place decontamination equipment inside the work area. Reference decontamination procedure,
per NSF/ANSI 49, Annex I-2 (formerly Annex G), using the following chart to calculate chemical requirements.
BE SURE CABINET IS TOTALLY SEALED TO PREVENT ANY
LABORATORY EXPOSURE TO DECONTAMINATION GAS.
Cabinet Size 400 500 600
Cabinet
Dimensions
58-7/8 x 28 x 46-3/8
(1.50 x .711 x 1.18 m)
58-7/8 x 28 x 58-3/8
(1.50 x .711 x 1.48m)
58-7/8 x 28 x 70-3/8
(1.50 x .739 x 1.88 m)
Cabinet
Volume
44.24 cu. ft.
(1.25 cu. m)
55.69 cu. ft.
(1.58 cu. m)
67.14 cu. ft.
(1.90 cu. m)
CAUTION
!