Section 7
Service
Alpha Fuzion Sauna Body Pod
37
2. Removal of hinge plate
Remove the five screws and nuts that attach the hinge plate to the hood as shown
in 7.3.2
Removing Hinge Plate
. Account for all five screws and nuts.
CAUTION: Do not drop any parts into the heat duct or the heater.
Remove hinge plate and set aside.
3. Removal of heater air intake screen
On the side through which the heater harness cable protrudes, straighten black
tabs on the screen inside heater cavity, and remove screen as shown in Figure
7.3.3
Removing Heater Intake Screens
.
4. Removal of heater harness
Loosen strain relief bushing by turning plastic nut from the outside of the duct with
a wrench as shown in Figure 7.3.4
Removing Heater Harness
.
NOTE: It may be
necessary to use a second wrench to hold nut inside the heater cavity, as
well.
Grasp the harness and slide out of notch in screen opening. Push harness
and connector through the vacant screen opening and into the heat duct. Next,
pull the harness up through the hinge plate opening.
5. Removal of heater
Grasp heater brackets and pull heater assembly straight up toward you, tilting
slightly to prevent any damage to the wires, connectors, or terminals located on
either side of heater as shown in Figure 7.3.5
Removing Heater
.
Figure 7.3.2 Removing Hinge Plate.
Figure 7.3.3
Removing Heater Intake Screens.
Center
Screw
2
4
3
Содержание Alpha Fuzion
Страница 1: ...206507 NA AF 10 0813 2 U...