NuAge Beauty Alpha Fuzion, Руководство пользователя, Страница: 40 / 103

Section 7 Service
Alpha Fuzion Sauna Body Pod
35
7.2 Replacing the Hood onto Base Chassis
•
Precautions:
1. Disconnect from power source before beginning this procedure.
2. Two people are needed to perform this procedure.
•
Tools Required:
Adjustable or ½ inch wrench
•
Hood Replacement:
1. With two people on opposite sides of the hood, grasp the lower edge to lift as shown
in Figure 7.1.3 Removing the Hood . To evenly distribute the weight of the hood, place
hands approximately 15 - 20 inches from each end of the hood.
2. Carefully lift hood over base chassis and align hinge plate with hinge assembly as
shown in Figure 7.1.3 Removing the Hood .
3. Align hinge plate pins with slots on hinge assembly. Gently allow hood to slide down
onto hinge assembly until the hood pins are fully seated in slots as shown in Figure
7.2.1
Hood Alignment of Pins and Hinge Assembly. Hole in hinge assembly above
struts should align with hole in hinge plate. Insert black flange bolt, but do not tighten
completely (95%).
4. Slowly lower the hood down to meet the base and verify proper alignment and seating
of the hood/base contact area.
5. Slowly raise hood to full open position, maintaining alignment. Tighten flange bolt.
6. Re-connect harnesses from hood to base as shown in Figure 7.1.1
Releasing
Electrical Connectors .
•
Align grooves/slots on each half of the electrical connector, so they fit
together.
•
When electrical connector halves are seated, tighten threaded rings at
bottom of the connectors in a clockwise rotation until locked .
Figure 7.2.1 Hood Alignment of Pins and Hinge Assembly.