3
Preparations and Flow of Data
Communication
The preparations required for performing packet and
64K data communication by connecting the FOMA
terminal to a PC are given below.
When you use the
FOMA PC setup
software
Install the communication configuration files (drivers) (P.4).
Connect the FOMA terminal to a PC (P.3).
Check the communication configuration files (drivers) (P.5).
Set a host.
Packet communication
“mopera U” or
“mopera” (P.7)
Other provider (P.8)
Perform communication (P.9).
Start up communication software that is
compatible with AT commands (P.11).
Set a host (P.11).
Set ON/OFF for the Notify caller ID (P.12).
Set up the dial-up network (P.12).
Perform the dial-up connection (P.15).
When you do not use
the FOMA PC setup
software
64K data
communication
“mopera U” or
“mopera” (P.8)
Other provider (P.9)
Install the FOMA PC setup software (P.6).
Connecting the FOMA Terminal
to a PC
Connect the FOMA terminal to a PC when they are
powered on.
1
Open the external connection terminal cover.
2
Insert the external connection connector of the
FOMA USB connection cable (optional) into the
external connection terminal of the FOMA terminal
until it clicks.
3
Connect the USB connector of the FOMA USB
connection cable to the USB terminal of the PC.
The FOMA terminal is connected to the PC and “ ” is
displayed on the FOMA terminal.
3
1
2
USB connector
External
connection terminal
Insert the con-
n e c t o r h o r i -
zontally with
the label side
facing up.
External connection
connector
FOMA USB connection cable
USB terminal
■
Disconnecting the USB connection cable
1
Make sure to pull out the FOMA USB connection
cable horizontally while holding the release buttons
pressed.
When you remove the USB connection cable, “ ” which is
displayed on the FOMA terminal disappears.
Release buttons
Forcibly pulling out the
FOMA USB connection
cable may cause
malfunction.
2
Pull out the FOMA USB connection cable from the
USB terminal of the PC.
●
Do not remove the FOMA USB connection cable during
data communication. Doing so may cause malfunction,
etc.
●
It is after installing the communication configuration files
that “ ” appears on the FOMA terminal.
Содержание FOMA SO703i
