NTT docomo FOMA N703iD, Руководство пользователя

Страница: 60 / 500

58 Voice/Videophone Calls
● If a videophone call is not connected
When a videophone call is not connected, the cause of the failure appears.
● The cause may not appear depending on the situation.
● Depending on the type of phone used by the called party and the possible lack of a network service subscription,
the reason may not accurately reflect the other party’s actual status.
■
Auto redial as voice setting
● If the videophone call is not connected, your call is automatically switched to a voice call when you set “Auto redial
as voice” to “ON”. The operation of “Auto redial as voice” setting is as follows:
However, the call may not be handled in this way if you call an ISDN synchronous 64K, PIAFS access point, ISDN
videophone which does not support the 3G-324M standard (as of December, 2006) or if you dial a wrong number.
Note that call charge may be applied in some cases.
●
“32K” Connection speed is for videophones or other devices such as PHS mobiles that cannot communicate at
“64K” due to network conditions. If you make a videophone call at “64K” and the other party is in a “32K” area or
similar situation, the call is automatically redialed at 32kbps. However, note that “32K” videophone calls attract the
same digital communication charges as “64K” videophone calls.
Display Cause
Check number then redial The called phone number is not used
Busy The line is busy
・ This message may also appear during packet communication
Busy with packet transmission The other party is using packet communication
Out of service area/power off The other party is out of service area or the phone is turned off
Set caller ID to ON You connected without notifying your caller ID (when dialing into
visualnet)
Your call is being forwarded The call is being forwarded (A Videophone call is made when the
forwarding number is for a 3G-324M-compatible videophone)
Redial using voice call The phone for the forwarding number is not compatible with videophone
calls
Please activate caller ID before dialing again The other party is set to the Caller ID request service
At the use’s request, your call cannot be connected The other party is set to the Nuisance call blocking service
Upper limit has been exceeded Connection failed The upper limit set for a Limit billing plan (Type Limit and Family Wide
Limit) is exceeded
Connection failed Set the caller ID notification to “ON” and retry
・ This message may also appear in other situations
Please make your call from the i-mode web page You attempted to make a videophone call to watch V-line without
browsing the i-mode official site
Connection speed Auto redial as voice “ON” Auto redial as voice “OFF“
Dialed at the Connection speed of “64K” and the
connection failed Redialed at the Connection speed of
“32K” Redialed at the Connection speed of
“32K”
Dialed at the Connection speed of “32K” and the
connection failed Redialed as a voice call Not redialed