![NTT docomo FOMA N703iD Скачать руководство пользователя страница 397](http://html1.mh-extra.com/html/ntt-docomo/foma-n703id/foma-n703id_manual_1715379397.webp)
395
Continued on next page
Appendix/Using the FOMA Terminal with External Devices/Troubleshooting
The display is hard to view.
●
Is the brightness setting of the backlight set to “Level 1”?
●
Is “Privacy angle” set to “ON”?
P.120
P.120
The display and backlight of the
keypad do not turn on.
●
Is Lighting of the backlight set to “OFF”?
●
Is the lighting area set to “LCD” ?
●
The brightness may not be detected correctly when the illuminance sensor is
covered with a finger or depending on the illuminant.
P.120
P.120
P.120
When I receive an incoming call
immediately after turning on the
power, the phone number is
displayed but the name stored in
the Phonebook is not.
●
The FOMA terminal may be reading the FOMA card (UIM) immediately after
turning on the power. The Phonebook function may not be available during that
time.
−
It takes some time for the power to
turn on after
y
is held down for
1 second or longer.
●
When Phonebook, etc. has reached full capacity, data verification takes some
time.
P.102
Nothing appears on the display.
●
Is the FOMA terminal set to Power saver mode? Press any key to cancel Power
saver mode.
P.120
Nothing appears on the indicator
display.
●
Is “Indicator display” set to “OFF”?
P.124
No incoming call reaction (ring
tone sounding, vibrator, incoming
call lamp flashing) is performed
when a call comes.
●
No incoming call reaction (ring tone sounding, vibrator, incoming call lamp
flashing) is performed until the set time has passed when you receive a call
from a phone number not stored in the Phonebook or from a caller who does
not notify its caller ID if “Set mute seconds” of “Ring time (sec.)” is set “ON”.
P.156
The figure of the accumulated
charge does not increase.
●
The figure does not increase when it reaches to the limit. Perform “Reset total”.
P.330
When I receive SMS, the name
stored in the Phonebook is not
displayed.
●
Did you correctly store the phone number of the sender on the phone number
line (
) of the Phonebook?
P.93
Mails are not automatically
filtered.
●
If the other party’s mail address is “Phone [email protected]”, register the
telephone number only in the Auto-sort settings.
●
If the other party’s mail address is other than “Phone [email protected]”,
register the complete address including the domain in the Auto-sort settings to
be automatically allocated.
P.229
P.229
Mails are not automatically
received.
●
Is “Receive option setting” set to “ON”? Set to “OFF”.
P.220
P.234
I cannot perform the N703iD
communication setting file
(drivers) installation or data
communication.
●
Is USB mode set to “microSD mode”? Set to “Communication mode”.
P.297
I cannot connect to i-mode, i-mode
mail, i-
α
ppli or i-channel.
●
Is “Host selection” set to other setting than “i -mode”.
●
If you have subscribing to the i-mode Service after purchasing the terminal, turn
the FOMA terminal off and then turn it back on.
P.194
−
Even if mail has been received, no
incoming call reaction (ring tone
sounding, vibrator, incoming call
lamp flashing) is performed.
●
Is “Mail/Msg. ring time” set to “OFF”?
●
Is Original lock set to “Disp. recv. mail/msg.” of “Incoming/Mail disp.”?
●
Is “Receiving display” set to “Operation preferred”?
P.114
P.145
P.234
Sent mail does not remain in the
Outbox.
●
Is “Sort all” set to the folder of a mail-connected i-
α
ppli?
Highlight the folder of mail-connected i-
α
ppli and then select “Open folder” from
the function menu to confirm.
P.229
Received mail does not remain in
the Inbox and “
” does not
disappear.
●
Is “
” appear on the folder of a mail-connected i-
α
ppli in the Inbox? Or, is
“Sort all” set to the folder of a mail-connected i-
α
ppli? Highlight the folder of the
mail-connected i-
α
ppli and then select “Open folder” from the function menu to
confirm.
P.227
P.229
Mail sending is interrupted, SMS
is received, and a message
appears when retrying.
●
When the amount of data communication within a specified time is too much,
the line is interrupted and notified with SMS. Follow the contents of SMS and
the displayed message.
−
When shooting pictures, the
images are flickered.
●
When you take pictures indoors, flickering may appear due to the effect of
fluorescent lighting, etc. The flickering may be suppressed by changing the
“Image tuning” setting.
P.167
Still images or movies shot look
too bright.
●
Haven’t you shoot still images or movies outside or in a bright place with “Image
tuning” set to “Mode 1 (50Hz)” or “Mode 2 (60Hz)”? Check the tuning and make
sure it is reset to “Auto”.
P.167
Problem
Points to check
Ref. page
Содержание FOMA N703iD
