SPLITMUX Quad Screen 4K 18GB Multiviewer
62
The IP address shown here
is only used when the IPv4
Mode is set to “STATIC”.
To quickly view the IP address
when the mode is set to
“DHCP”, go to the “System
Information” page (page 70).
Figure 59- OSD IP Settings
IP Settings
Mode
Select the method for acquiring IP Settings- Static (manual), DHCP (automatic) or Disable
IP Address
Enter valid IPv4 address (for Static Mode)
(default is 192.168.1.30)
Subnet Mask
Enter valid subnet mask (for Static Mode)
Default Gateway
Enter valid default gateway (for Static Mode)
Primary DNS Address
Enter preferred name server (for Static Mode)
Alternate DNS Address
Enter alternate name server (for Static Mode)
Note: If you select “DHCP” for the mode, make sure a DHCP server is running on the network the SPLITMUX is
connected to.
Figure 60- OSD Server Settings
Server Settings
Enable Telnet
Change to “Enable” to permit access to the SPLITMUX via Telnet
The default is disabled.
Enable HTTP
Change to “Enable” to allow access to the SPLITMUX via standard (non-secure) HTTP requests
The default is disabled.
HTTP Port
Port to be used for standard HTTP (non-secure) requests (default is 80)
HTTPS Port
Port to be used for HTTPS (secure) requests (default is 443)
Web Timeout
Number of minutes after which idle web users will be logged-out (maximum is 32000, enter 0 to disable
this feature)
