SPLITMUX Quad Screen 4K 18GB Multiviewer
40
Telnet Control
To control the SPLITMUX using telnet from the command line, the SPLITMUX must first be connected to the Ethernet.
Note: Telnet must be enabled through the web interface (page 20) for a connection via Telnet to be possible and the user
must be on the same subnet as the SPLITMUX
.
To open a telnet session to the SPLITMUX, issue the following command from the command line:
telnet
<
SPLITMUX
IP address
> 2000
<
SPLITMUX IP address
> is IP address of the SPLITMUX (default is
192.168.1.30
).
The user will be prompted for the root password to connect to the SPLITMUX.
The factory default password is
"nti".
(all lowercase letters).
With a proper password sent the SPLITMUX will respond with:
Password Successful
Connection Established
The commands below are now usable:
Command String
Good Response
Description
CS
,ip
,01
*<CR>
Connect input X to the output port
CM,
mode
,01
*<CR>
Change the mode of the switch
CF
Login Prompt
Open Text Menu
CB 00,
BR
None
Change baud rate of serial line,
BR=11(5200),57(600),38(400),19(200)96(00),48(00),24(00),12(00)
Factory default is 115200
LA,
nn
*<CR>
Load saved custom layout (01-10)
RU *<CR>
IP,OP
<CR>
Read Unit Size
RS *<CR>
Reboot
unit
Note: When making a Telnet
connection through any terminal
software, be sure to configure to
connect through port 2000.
