SPLITMUX
- Installation and Operation Manual
ON SCREEN DISPLAY
2
Example of DCP control
A
SPLITMUX
is controlled via DCP-XML by a computer connected by serial cable or USB.
For an introduction to the DEVICE CONTROL PROTOCOL please Annex.
DCP synchronize
OSD - SYSTEM - CONTROL
Important:
Each time you restart a
SPLITMUX
set to
synchronize
, it will send all its settings to the next
connected device. This process also takes place after activating
synchronize
in the OSD menu.
When starting a chain of devices, always start by
first
switching on the device
at the end of the chain
.
When the device has completed its startup phase and sent its DCP messages, switch on the next device
in the chain.
Finally, switch on the first device in the chain, which synchronizes the settings of all other devices in the
chain with its own settings as it starts up.
Computer
controls
DCP-XML
USB or COM
ports
Rear Panel
Use this mode to keep several
SPLITMUX
devices in the same mode.
Every change in settings initiated in the first
SPLITMUX
by
hotkeys
, h
otmouse
,
front panel
buttons or
controlling devices
synchronizes the
modes of all connected devices via DCP messages.
Use special Y-cables for the synchronization.
Содержание SPLITMUX-DVI-4RT
Страница 52: ......
Страница 89: ...SPLITMUX Installation and Operation Manual ANNEX 84 DECLARATION OF CONFORMITY...
Страница 109: ......