NPK G015, Инструкция по эксплуатации

Страница: 53 / 60

- 52 -
THROTTLE ADJUSTMENT
ADJUSTMENT OF FLOW TO THE HYDRAULIC MOTOR
The following diagram shows the guide values for adjustment of the throttle. Before
adjustment, screw the throttle clockwise in until it stops
(do not jam it in) . By turning the
throttle counterclockwise, you can adjust to the desired delivery rate.
gr01 Eccentric revolutions per minute
gr02 Delivery rate of the G025-5040 – fl. oz./min.
(cu.cm/min)
gr03 4350 psi (300 bar)
gr04 3625 psi (250 bar)
gr05 2900 psi (200 bar)
gr06 2175 psi (150 bar)
gr07 Turns of the throttle adjustment
NOTE: Adjustment of the eccentric’s revolutions is made by an adjusting
throttle. Each pump must be adjusted individually. The values of the
throttle rotations in the table above are to assist adjustment.
If the required delivery rate is not known, you can assume a range between .016 fl.
oz./min.
(0.5 cu.cm/min.) and .034 fl. oz./min. (1.0 cu.cm/min.) for most hydraulic
hammers.
10 to 11.5 full turns of the throttle screw (from closed) will give an eccentric speed of
35 – 40 RPM’s and an output of 1.44 lbs./hr.
(.65 kg/hr. ).