Novexx Solutions 64-04, Руководство пользователя

Страница: 322 / 438

06/15 Rev. 10 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
56
Measure

Please read the notes in section General software errors  .
5504 No RFID job
Status A print job, which is not declared as RFID printjob, contains RFID-specific
Easy-Plug commands (e. g. #RT, #RFW, …).
RFID printjobs are declared in the #IM command by defining the distance
between label edge and optimum of transponder antenna (parameter "d").
Measure  Modify the print job.
5510 RFID COM timeout
Status Timeout error. There was no communication between reader module and
COM2 in the time slot where it should be performed.
Measure  Repeat the operation, in the course of which the error occured.
 Check, if the reader module board is connected correctly.
 Check if the reader module board is defective.
5512 COM open failed
Status There was a communication problem at COM2 while powering up the
printer. The interface cannot be opened by the printer firmware – or it is
used by another firmware part.
Measure  Check, if COM2 is available (that is, if it is built-in).
 Check the function of the COM2 interface.
5513 Get baud failed
Status There was a communication problem between COM2 and reader module
while powering up the printer. The baud rate of the reader module is not
detected correctly by the printer firmware. Baud rate and/or parity and/or
another setting of transmission parameters at the reader module is faulty.
Measure  Check, if the reader module board is connected correctly.
 Check if the reader module board is defective.
 Check the setting of the transmission parameters at the reader module.
5521 No transponder
Status Either there is no transponder (=tag) or more than one transponder within
reach of the antenna.
Measure  Check the label material feeding; remove paper jam, if necessary.
5522 Tag write err
Status A transponder (=tag) cannot be written on for one of the following reasons:
•
Faulty address: e.g. an attempt to write into a protected area.
•
The tag is out of reach of the antenna, after it has already been recognized.
•
Noise signals avoid the transmission.
Measure  Check the system for the mentioned error causes and correct them.