Novexx Solutions 64-04, Руководство пользователя

Страница: 217 / 438

06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
100
APPLICATOR PARA

This menu only appears in printers of the types DPM, PEM and ALX 92x,
and only, if the optional Applicator Interface (AI) is connected.
Applicator type
ALX 92x DPM

Only with an AI installed.
Selection, which applicator type will be applied:
LTP-LTPV LTP = Light Touch Pneumatic
LTPV = Light Touch Pneumatic Vacuum
Applicator with „Light Touch“ function. „Light Touch“ means, that the move-
ment of the (compressed air) cylinder is limited by sensors, which react to a
light touch onto the product. The LTPV additionally sucks the labels on with
a vacuum nozzle.
Advantages:
•
Application on products with different heights possible
•
Only light pressure onto the product (important with sensitive products)

Refer to Technical Manual LTP/LTPV  .
PEP The cylinder movement is limited by a setable length of time. After the run out
of this application time, the cylinder moves back into home position.
PEP Blow on
PEP-type applicator with blow on function: After run out of the application
time, the blow on function is activated. After run out of the blow on time, the
applicator moves back into home position.
PEP II Sensor The cylinder movement is limited by a (touch down) sensor, which signals the
contact to the product and triggers the backwards-movement.
ASA
ASA = Air stream applicator. This applicator type has no moving parts, but
blows the label onto the product (also called „blow box“). After the start signal,
the blow on valve is opened for a setable time length.
Reverse PEP This applicator is partly time related. Working procedure:
The applicator moves to its end position and “waits“ for the start signal. The
start signal triggers the blow on valve which is active for the defined blow on
time. After the run out or the blown on time, the applicator moves to home
position, gets the next label and moves to the wait position.
Direct Dispense
Dispensing with dispensing edge (without applicator).
BTS
BTS = Bad tag separator. This device does the opposite of an applicator: it
removes labels from the dispensing edge of a labeller. The BTS is used for
sorting out RFID labels, which could not be read/written properly.
O-ring applicat. Setting for an O-ring applicator.
LA-BO L abel A pplicator B low O n.

For details refer to the User Manual LA-BO 
LA-CE L abel A pplicator C orner E dge, applies the label around a corner edge.