Nova gear NG-51, Инструкция по эксплуатации

Страница: 12 / 20

12
Fig.3
INSTALLING DRILL OR DRIVER BITS
1. Remove the battery from the drill.
2. Rotate the keyless chuck to a point
where the opening is slightly larger
than the drill or driver bit you intend
to use.
3. Insert the drill or driver bit into the
keyless chuck, ensuring the end of the
drill or driver bit does not touch the
screw inside the keyless chuck.
4. Tighten the keyless chuck onto the
drill or driver bit (Fig. 3).
REMOVING DRILL OR DRIVER BITS
1. Remove the battery from the drill.
2. Loosen the keyless chuck as
described previously.
3. Remove the drill or driver bit from
the keyless chuck.
NOTE: Do not handle drill bits
without gloves as drill bits and other
accessories are sharp or can be hot
after use, this can cause personal
injury.
OPERATION
ON / OFF TRIGGER
1. Turn the drill ON by pressing the on /
off trigger (Fig. 4).
2. To turn the drill OFF release the on
/ off trigger.
On / off trigger
Fig.4