Nova gear NG-51, Инструкция по эксплуатации

Страница: 15 / 20

15
Fig.8
LED light
The torque setting required to drive
screws will differ with different
materials. Start with the torque setting
on the number you think is appropriate
(Eg: 4) and simply increase the torque
adjustment collar to a higher number if
the screw head is not sitting flush with
your work piece. Remove the screw
after adjusting and re-drive the screw
back into the work piece until the
correct torque adjustment leaves the
screw head flush with your work piece.
LED LIGHT
› The drill has one LED Light built into
the unit (Fig. 8).
› The LED light turns on automatically
when you press the on / off trigger.
› The LED light illuminates dark areas
in tight corners to assist with drilling
and screw driving. This helps achieve
a more accurate result in your work
piece.
DRILLING IN ALL MATERIALS
› Always use sharp drill bits.
› Mark the place where you would like
the hole to be drilled.
› Commence with a slow speed to start
the hole (see section “Speed Control”
for directions on how to do this).
› Reduce your pressure on the drill
when the drill bit is about to break
through the material.