Nova gear NG-51, Инструкция по эксплуатации

Страница: 16 / 20

16
MAINTENANCE
› When not in use, the drill should be
stored in a dry, frost free location, out
of reach of children.
› Keep ventilation slots of the drill
clean at all times and prevent any
foreign matter from entering.
› If the housing of the drill requires
cleaning, do not use solvents but a
moist soft cloth only.
› Blow out the ventilation slots with
compressed air periodically.
NOTE: Nova Gear will not be
responsible for any damage or
injuries caused by repair of the drill
by an unauthorised person or by
mishandling of the drill.
WASTE DISPOSAL
& RECYCLING
SERVICING
Do not dispose of this product
in household waste!
Please recycle this product
responsibly in accordance with
local and national law.
For information on servicing
and repairs please contact
Spot-on on 1300 658 338 or
visit www.spoton.com.au.
METAL DRILLING
› Support thin material with a piece of
scrap wood.
› Use a centre punch to mark the
position of the hole.
WOOD DRILLING
› Mark the place where you want to drill
with a punch or a nail.
› To avoid splintering on breakthrough,
either clamp a piece of scrap wood to
the back of your work piece or continue
the hole from the back of the wood
when the drill bit first breaks through.
› If drilling a large hole, use a small size
drill bit first to establish a pilot hole then
use the required large size drill bit.
› Use only HSS (high speed steel) drill
bits or those recommended for metal
use.
› When drilling into iron or steel, use a
cooling lubricant such as thin oil. With
aluminium, use turpentine or paraffin.
With brass, copper and cast iron, use no
lubricant but withdraw the drill regularly
to assist cooling.